There could be scenarios where the user would like to manually(via JTAG)
configure the DDR/L2SRAM and load the bootloader binary onto DDR/L2SRAM.
This document explains thse usecases and the detailed explanation of what needs
to be done to use it.
Most of the code from CONFIG_SYS_RAMBOOT will be used except for small changes
of CCSRBAR etc.
The changes are not very large, but it is good to document them so that user
can get it working at once.
Signed-off-by: Poonam Aggrwal <poonam.aggrwal@freescale.com>
Signed-off-by: Andy Fleming <afleming@freescale.com>
This patch series adds support for ZFS listing and load to u-boot.
To Enable zfs ls and load commands, modify the board specific config file with
#define CONFIG_CMD_ZFS
Steps to test:
1. After applying the patch, zfs specific commands can be seen
in the boot loader prompt using
UBOOT #help
zfsload- load binary file from a ZFS file system
zfsls - list files in a directory (default /)
2. To list the files in zfs pool, device or partition, execute
zfsls <interface> <dev[:part]> [POOL/@/dir/file]
For example:
UBOOT #zfsls mmc 0:5 /rpool/@/usr/bin/
3. To read and load a file from an ZFS formatted partition to RAM, execute
zfsload <interface> <dev[:part]> [addr] [filename] [bytes]
For example:
UBOOT #zfsload mmc 2:2 0x30007fc0 /rpool/@/boot/uImage
References :
-- ZFS GRUB sources from Solaris GRUB-0.97
-- GRUB Bazaar repository
Jorgen Lundman <lundman at lundman.net> 2012.
56376c4288